Questions & Answers

Q: QuestionWhat is the impedance compatibility of this amplifier?

• A:Answer This amplifier is compatible with both 4-ohm and 8-ohm impedance speakers.

Q: QuestionWhat is the total harmonic distortion and noise rating of this amplifier?

• A:Answer This amplifier has a total harmonic distortion and noise rating of 0.003%, which helps deliver clear audio.

Q: QuestionDoes this amplifier have a built-in DAC?

• A:Answer Yes, it has a built-in 32-bit DAC to ensure high-quality audio reproduction.

Q: QuestionHow much power does this Arcam integrated amplifier use per channel?

• A:Answer This Arcam integrated amplifier uses 50W of power for each of the two channels.

Q: Questionis this integrated amp 170wpc or 85wpc?

Asked 6 years ago by skiking.

• A:Answer it's 85 watts per channel or 170 watts total into 4 ohms. please note that they are 50 watts per channel into 8 ohms.

  Answered 5 years ago by nino

  Helpful (4)Unhelpful (0)ReportAnswer this question

Q: QuestionGreetings does this unit have Dirac room correction?

Asked 6 months ago by TVbuyer.

Q: QuestionCan these.be run bridged? Buy 2 one left channel one right channel? Tks

Asked 10 months ago by Anonymous.

Q: QuestionWhat good is having pictures of this product when you can't even zoom in and read all the inputs and outputs on the back of the unit ? You can zoom in but you can't read it !!

Asked 10 months ago by Frank.

Q: QuestionDoes this device support 220-230v? from the back images, does seem like it could switch voltages (110 vs 220). TIA.

Asked 2 years ago by satpak.

• A:Answer Yes has worldwide voltage selector

  Answered 9 months ago by Dealzguy

  Helpful (0)Unhelpful (0)ReportAnswer this question

Q: QuestionWill this drive my ineffecient headphones with plenty of power? I have Hedd Heddphone of 47 ohms with 87 efficiency rating. I prefer an answer from a audiophile.

Asked 3 years ago by Cstew.

Q: QuestionCan I play music wirelessly (Bluetooth) on the ARCAM SA10?

Asked 4 years ago by MHB.

• A:Answer This doesn’t have a Bluetooth, but you can buy a good quality BT TX/RX and use the optical or coax digital output to input into this amp. The DAC used is pretty good. It is a fantastic IAmp.

  Answered 9 months ago by dealzguy

  Helpful (0)Unhelpful (0)ReportAnswer this questionShow more answers (2)

Q: QuestionI am using an Anthem MCA 20 power amp running Magneplaner MG-12 speakers The pre amp was an Anthem TLP-1 would this work as a replacement for the TLP-1 ?

Asked 5 years ago by Bill.