“Hi, How many fan pins socket does this motherboard have for the case fans? 4 pin or only 3 pin?”
Answer This Question
1-1 of 1 Answer
It has 3, 4pin headers on it for system fan 1, system fan 2, and the CPU. I recommend if you buy this system and you want a good cool and fast pc remove the 3 pin dc fans that come installed and buy you 2. 120mm Corsair ML pro 120 led fans with the 4 pin wire. cause these are PWM fans. and get you a cpu fan that has 4 pin pwm. as this you will be able to go into the bios and set it up to run all 3 fans in PWM mode and Smart fan operation based on temp. and save energy. cause uses less dc volt at low rpm. because the way its set up from the factory is with 3 DC full run fans. meaning they stay at full speed all the time which is a bit annoying. also you will need a wire that has coating on it to tie around the heat pipe of the GPU and hang it from the top of the chassis. because the video card is heavy and there is sag on the front and if not corrected can over time shorten the life of it and damage the card. they make brackets you can buy but there online from companies direct. I found that using a wire as long as u don't put to much tension on it ur fine you want the board to be straight but not tight to the socket with stress cause is just as bad as having no support either. I also took out the factory ram. and put 4 sticks of DDR4 2400 MHz Ram From Corsair. the Vengeance LED. and I took out the small puny 450W power supply that it comes with from evea. and installed a 850w evea power supply that is cable free. which means u don't have all the unnecessary wires you don't need and the only one you will need extra is plug and play. for good cable management. and 450 w from the factory isn't quite enough if you have all the settings on and playing hard core graphic games. the processor is good. the video card is good. they are phenomenal, as long as u have enough juice to them.
Sorry, there was a problem. Please try again later.
