“The directions say a 3/17 inch drill bit needs to be used for the lag bolt pilot hole, but I do not believe that size exist? I am only aware of 3/16 inch? Can anyone clarify?”

1-2 of 2 Answers

• Yes, use the 3/16 inch drill bit, the lagbolt is ST8*60mm.

  Answered by DynexCustomerSupport 5 years ago

  Helpful (0)Unhelpful (0)

  Report

  Sorry, there was a problem. Please try again later.

• Haha I had the same confusion. So I just used the 11/64 drill bit (0.172" vs. 0.176" for 3/17) and it worked fine.

  Answered by DavidinMI 5 years ago

  • Verified Purchase
  • 

  Helpful (0)Unhelpful (0)

  Report

  Sorry, there was a problem. Please try again later.