A:AnswerHi Roberto! I could not find a published spec showing the exact height of the dryer‑vent outlet (i.e., the distance from the floor to the vent collar) for the Electrolux Laundry Tower Single Unit Front Load 4.4 Cu. Ft Washer & 8 Cu. Ft Electric Dryer (model ELTE7300AW).
What is available:
- Overall height of the unit is 76¼ inches.
- Width: 27″; Depth: 32″.
- The spec sheet simply lists “Ventilation Type: Vented” but does not give the location height of the vent outlet.
Recommendation: Since the vent outlet height is critical for fitting into your space, I suggest one of the following:
- Measure the rough‑in where the unit will go (wall or floor) and allow some vertical flexibility since the actual vent collar on the dryer may be several inches off the back and not purely flush.
- Contact the manufacturer (Electrolux) or check the full installation guide/kit for the model; sometimes that detail appears in the installer manual rather than the consumer spec sheet.
- When installing, plan for typical clearances: many stacked units place the vent collar behind the dryer top section at roughly mid‑height of the dryer section, but this can vary; allow extra margin. - Maico
A:AnswerHi, dude! The Electrolux laundry center model ELTE7300AW weighs 339 pounds. This weight applies to the combined washer and electric dryer unit. - Patrick
A:AnswerWasher door bottom edge sits at ~53″ from the floor. The dryer sits directly above the washer, separated only by the central control panel (typically ~6″ in height). So: Top of washer door ~53″ + washer door height (~15″) = ~68″. Dryer door bottom will be just below that—likely around 65–67″ above the floor. - Jessica
A:AnswerHi there, Dimensions & Accessibility: Height to bottom of drum opening (washer): approximately 53 inches from the floor. Washer drum depth from front edge to the back of the tambor: about 26 inches.
- Jessica
A:AnswerThe Electrolux Laundry Tower Single Unit Front Load Washer typically has a pump filter located at the bottom front of the unit. This filter is responsible for catching debris, lint, and small objects that might end up in the wash. You can remove the filter, and it is accessible for you. Kindly check the link attached and see page 67. - Jessica https://content.syndigo.com/asset/336c19de-eb48-43a5-9ad3-c71a113e194d/original.pdf
A:AnswerEven on a brand-new washer, smelly laundry usually points to one of the following: 1. Low Water Use + Detergent Residue 2. Cold Wash Cycles Too Often 3. Washer Door/Gasket Holding Moisture. The Electrolux Laundry Tower is indeed marketed as quiet, so if yours is noisy, something may be off. Here's what to inspect: 1. Washer/Dryer Leveling 2. Shipping Bolts Still Installed 3. Clothing Overload or Unbalanced Loads 4. Dryer Duct/Vent Issues. If issue still persist, you can reach out to your dealer or manufacturer for assistance. - Jessica
A:AnswerHi there, thank you for reaching out to us regarding your inquiry. To avoid restricting the
outlet, maintain a minimum of 12 inches (30.5 cm) clearance between the vent hood and the ground or any other obstruction.
- Jessica
A:AnswerHi there, thank you for reaching out to us regarding your inquiry. The Cancel button is located at the right side of the washer under the Start/Power button.
- Jessica
A:AnswerHi, Samuel. Yes, with this model, you can wash and dry at the same time. The washer and dryer are separate units, so while the washer is running a wash cycle, the dryer can be drying a separate load of laundry. This allows you to efficiently handle multiple laundry tasks simultaneously. - Maria
