A:AnswerThank you for your question.
For the Frigidaire Gallery 30" Gas Cooktop (stainless steel), the five burners have the following BTU ratings:
Front Right (Quick Boil burner): 18,000 BTU
Front Left: 12,000 BTU
Rear Left: 9,500 BTU
Rear Right: 7,500 BTU
Center (Simmer burner): 5,000 BTU
This configuration provides a range of heat outputs—from a high-powered burner for rapid boiling to a low BTU burner designed for gentle simmering and delicate cooking tasks. - Jessica
A:AnswerHello there, Yeahtom! The official Frigidaire gas cooktop installation requirements and clearances (as shown in the manufacturer’s manual for 30″ Frigidaire gas cooktops):
1. Frigidaire Cooktop Clearance Requirements
- *Minimum clearance from the top of the cooktop surface up to the bottom of any unprotected wood/metal overhead cabinet: 30″ (76.2 cm).
- If the overhead surface is protected (flame‑retardant millboard + sheet metal), that minimum can be 24″.
Overhead cabinets should not exceed 13″ maximum depth above the cooktop.
This 30″ clearance figure is a standard minimum vertical distance intended to reduce fire and burn risk from cooktop heat and burner flames.
2. About Installing a Microwave Above the Cooktop
The Frigidaire gas cooktop manual itself does not explicitly list a microwave (like an over‑the‑range microwave) as an approved overhead appliance or give a specific clearance for it.
- The manual’s spec is written in terms of clearance to overhead cabinets — not a microwave.
- Because the manual doesn’t mention microwaves, Frigidaire is not confirming that this gas cooktop can legally be installed directly under a microwave in the same way they do for some built‑in combinations (e.g., cooktop over a wall oven).
3. So, Can You Install a Microwave Above It?
It does not approve a microwave installed above the cooktop because it only certifies clearances relative to cabinets and does not state an approved microwave clearance.
- To install a microwave above a cooktop safely, you must follow the microwave manufacturer’s own installation requirements — not just the cooktop’s manual — because a microwave introduces venting, heat exposure, and combustion clearance considerations that are not covered for gas cooktops alone. (This is why many microwave manuals specify clearances from the bottom of the microwave to the cooktop surface.)
4. If You Still Want to Install One
- The Frigidaire gas cooktop manual minimum clearance to a horizontal surface above is 30″ above the cooktop top — that’s the only figure the manual gives.
- If any microwave (even non‑OTR) is installed in that space, it must not violate that 30″ minimum unless the microwave’s own installation instructions allow closer clearances and local building codes permit it — which must be verified with both manufacturers and local code enforcement. - Maico
A:AnswerThank you for your question! To properly clean the stainless steel surface on your Frigidaire Gallery 30" Gas Cooktop – Stainless Steel, the burner grates will need to be lifted off the cooktop. The grates are designed to be fully removable for easy access to the surface underneath; however, there is no need to disassemble or take apart the entire grate assembly beyond simply lifting them off once the unit is completely cool.
After removing the grates, you can clean the stainless steel surface with a soft cloth and mild soapy water. For best results, dry the surface thoroughly to maintain the finish. We recommend avoiding abrasive cleaners, bleach, or ammonia-based products, as these may damage the stainless steel.
The grates themselves can be cleaned separately with warm soapy water and dried completely before placing them back on the cooktop. - Jessica
A:AnswerYes, the bottom of the grates have rubber padded cushions on them. The little padded cushions rest inside small circles on the stainless steel stove top base. Easy to remove the grates starting from the center, right, left. However, grates are heavy and sturdy.
A:AnswerHello, valued customer. We appreciate your inquiry. The conversion kit is an accessory for this model and can be bought separately. It is not included in the box. If L.P. If conversion is needed, contact your local L.P. Gas provider for assistance. We hope this information helps! - Christi
A:AnswerHello, Scott. We appreciate your inquiry. This model is not compatible with downdraft ventilation, does not feature built-in downdraft venting, and is not designed to be used with separate downdraft systems. We hope this information helps! - Christi
A:AnswerHello, Ruth. Thank you for reaching out to us. These are the cutout dimensions of the Frigidaire - Gallery 30" Gas Cooktop: Minimum cutout width - 27 1/4"; Maximum cutout width - 29 5/16". The minimum cutout depth is - 19" and the Maximum cutout is - 20". We hope this information helps. - Maria
A:AnswerHi Linda,
Thank you for reaching out to us! I’m sorry, but the Frigidaire Gallery 30" Gas Cooktop is not dishwasher safe. The burner caps, however, are dishwasher safe. It is recommended to clean the cooktop with a soft cloth and mild detergent.
I hope this helps! - Owen.
A:AnswerHi Windy! Thank you for reaching out to us. You can check the installation guide manual for better measurements. We hope this information was helpful to you and your shopping experience. -Christian
A:AnswerHello there, Avery. An LP conversion kit is included with the cooktop upon purchase. If L.P. conversion is needed, contact your local L.P. Gas provider for assistance. -John
