1-1 of 1 Answer
Hi kofahly396- Thanks for your purchase! We are happy to provide assistance. If an out-of-balance condition is detected by the washer, the Spin light will blink during the remaining portion of the cycle and will stay illuminated for a short time after cycle completion. When this occurs, the washer is taking actions to correct the out-of-balance condition and complete the cycle normally. In some cases, the washer may not be able to balance the load and spin up to full speed. If you notice the load is more wet than normal at the end of the cycle, redistribute the load evenly in the wash basket and run a Drain & Spin cycle. Also, check for oversudsing. Try less detergent. Measure your detergent carefully. Use less soap if you have soft water, a smaller load or a lightly soiled load. Switch to High Efficiency detergent. Electronics may need to be reset. Unplug washer and wait 2 minutes. If you need further assistance, we encourage you to contact GE Appliance Service at 1-800-432-2737 or conveniently schedule an appointment online: http://www.geappliances.com/service_and_support/service/ - We hope this is helpful. Thanks for reaching out to us! SUEatGEA
Sorry, there was a problem. Please try again later.