“How easy is this to install? I downloaded the installation instructions from the Best Buy site and it is the install of the stainless steel Unification Kit and the Panel Unification Kit. Would a normal layperson be able to just install one side panel?”
Answer This Question
1-1 of 1 Answer
I just did a right side panel today. Very simple. Clean the side of the fridge, because the panel is double sided taped on. Then you just remove a star bit screw off the top hinge cover and remove the rear corner protector (which is one 1/4 inch hex screw) for the side you are putting the panel on. The hinge cover will still be attached, but you just pry it up with your fingers when you clip the panel on. Open the door and freezer so the side panel doesn’t cut into the rubber seal as you clip the panel on. Remove the plastic of the double sided tape and press the panel into place. Replace the hinge cover screw and the corner protector and you’re done! Makes a world of difference in appearance, I wish it was included in the fridge in the first place.
Sorry, there was a problem. Please try again later.