Can I connect my audio-technical LP60 automatic stereo turntable directly to the insignia Bluetooth shelf speakers without a receiver? If so how as I have tried all different combinations. null

Question

Markz · Accepted Answer

Make sure you have the preamp enabled on the turntable and select the correct input on the speaker remote. The speakers won't automatically switch. You have to use the remote to select the input . Hope that helps.

Answered by Markz 9 years ago

Verified Purchase

audio17 · Answer

you can connect any turntable to the back of these speakers.You take the RCA cable coming out from your turntable right in to the RCA input jacks in the back of your main control speaker. It has 2 inputs, 1 mini stereo jack, 1 RCA input jacks. They are clearly marked "INPUT"

Answered by audio17 9 years ago

josh1624 · Answer

technically yes but also no. Turntables output a weak signal at best, it is basically a pre-preamp signal. you would have better luck putting a cheap phono preamp to boost the output to preamp levels then run it into you speakers. this setup will allow the cleanest sound and optimal volume levels to rock the whole neighborhood.

Answered by josh1624 8 years ago

bendken · Answer

I don't know what kind of output the turntable uses, but if it has an RCA output or an earphone type jack it should work. You must tell the speakers to accept the RCA or small plug signal.

BigMac · Answer

If you have a 3.5mm jack they would plug right in

shopper · Answer

No, you can't connect them to a turntable with a receiver or without. They only work with devices that support bluetooth

“Can I connect my audio-technical LP60 automatic stereo turntable directly to the insignia Bluetooth shelf speakers without a receiver? If so how as I have tried all different combinations.”

1-6 of 6 Answers