“On the rinse cycle it just keep spinning until last couple of minutes then it keeps spinning slowly and water comes in from the top but it never fills with water and agitated. Is this normal? I have a NS-TWM41WH8A MODEL.”
Answer This Question
1-1 of 1 Answer
It sounds like your Insignia NS-TWM41WH8A washer might be experiencing an issue. During the rinse cycle, the washer should fill with water and agitate to rinse the clothes properly. Here are a few potential causes and solutions: 1. Clogged Water Inlet Filters: The filters in the water inlet hoses might be clogged, restricting water flow. You can clean these filters by turning off the water supply, disconnecting the hoses, and cleaning the filters inside the hose connections. 2. Faulty Water Inlet Valve: If the water inlet valve is malfunctioning, it might not be allowing enough water to enter the washer. This part may need to be tested and replaced if faulty. 3. Pressure Sensor Issue: The pressure sensor, which detects the water level, might be faulty. If it fails, the washer might not fill correctly. This component may need to be checked and replaced if necessary. 4. Control Board Problem: There could be an issue with the control board not sending the correct signals to fill the washer during the rinse cycle. This would require professional diagnosis and repair. If you're comfortable with DIY repairs, you can try checking and cleaning the water inlet filters first. For more complex issues like the water inlet valve, pressure sensor, or control board, it might be best to contact a professional technician.
Sorry, there was a problem. Please try again later.