Questions & Answers

Q: QuestionIs this good for outdoors???

Asked 8 years ago by Ccc.

• A:Answer yes, just need electricity and cover it if it rains

  Answered 8 years ago by gramp3Verified Purchase

  Helpful (1)Unhelpful (0)ReportAnswer this questionShow more answers (1)

Q: QuestionHow cold will it get at the maximum setting ?

Asked 8 years ago by Chris.

• A:Answer It got to freezing up the lines, so I'm guessing below 32 degrees F. Works well, pop in a grill thermostat in the back where the CO2 hose goes in with wire to monitor the inside temps. I've been keeping mine at 39 degrees and it is plenty cold.

  Answered 8 years ago by DaveVerified Purchase

  Helpful (1)Unhelpful (0)ReportAnswer this questionShow more answers (1)

Q: QuestionWhat good is this cooler for 500.00 if your limited greatly with beer brands. Why not make in a bit bigger to fit most common brands. Other kegerators do.

Asked 8 years ago by Bob.

• A:Answer This kegerator fits all beer brands.. like any kegerator you need to either kegthe correct style of keg coupler ( euro kegs use different than sanke) or you need to get your Coors or Miller and ensure that it's not the oversized rubberized keg (full size) or keg the half or sixtel size Coors or Miller...

  Answered 8 years ago by Joeinohio

  Helpful (1)Unhelpful (0)ReportAnswer this questionShow more answers (1)

Q: QuestionDoes this keg come with a D coupler? I'd like to use it for corona. I'd also like to use it for Guinness, is that possible with this kegerator?

Asked 8 years ago by Taps.

• A:Answer It comes with the very-common type D keg coupler. Check the keg coupler type online for kegs you plan to purchase. Guinness is Type U. You'll have to purchase another keg coupler for Guinness.

  Answered 6 years ago by JoelVerified Purchase

  Helpful (1)Unhelpful (0)ReportAnswer this questionShow more answers (1)

Q: QuestionDoes the C02 canister fit inside with a 1/2 barrel keg?

Asked 8 years ago by kennylcx.

• A:Answer Yes. I had a 1/2 barrel of Labatt Blue with the canister inside.

  Answered 8 years ago by RobertVerified Purchase

  Helpful (1)Unhelpful (0)ReportAnswer this questionShow more answers (1)

Q: QuestionWhat is the height of the kegerator not including the draft tower? I'm looking to make a bar top that is level with it. Thanks

Asked 8 years ago by Dan.

• A:Answer 35 1/4 in with wheels and without the railing 32 1/4 in without the wheels and without the railing Hope this helps

  Answered 8 years ago by MikeInOhioVerified Purchase

  Helpful (1)Unhelpful (0)ReportAnswer this question

Q: QuestionWhat is the height of the top tray from the floor and how high if the tower? I have built a bar and need to know if it will fit underneath. Thanks for your help.

Asked 8 years ago by ROY.

• A:Answer Hello! The previously mentioned height is just for the fridge top, the entire unit is 45" height. Arely - Insignia Support i just copied this from a question someone asked on page three about the height

  Answered 8 years ago by danny

  Helpful (1)Unhelpful (0)ReportAnswer this question

Q: QuestionDo you have to defrost the Kegerator or does it defrost automatically?

Asked 9 years ago by Anonymous.

• A:Answer I had to manually defrost it

  Answered 9 years ago by Anonymous

  Helpful (1)Unhelpful (0)ReportAnswer this questionShow more answers (1)

Q: QuestionDoes a 1/6 keg fit?

Asked 9 years ago by Luke.

• A:Answer Absolutely it will fit and you should be able to actually fit 2 slim kegs for a dual tap configuration. This fridge is roomy enough I might try to squeeze in 2 slim and 1 corny kegs to see if triple tap might be an option. Stay tuned!

  Answered 9 years ago by Rodney95

  Helpful (1)Unhelpful (0)ReportAnswer this questionShow more answers (4)

Q: QuestionWill it hold a coors light 1/4 barrel?

Asked 9 years ago by Randy.

• A:Answer It holds 1 half barrel, 1 pony 1/4 barrel, or 2 slim 1/4 barrels

  Answered 8 years ago by skatardrummerVerified Purchase

  Helpful (1)Unhelpful (0)ReportAnswer this questionShow more answers (3)

Q: QuestionWhat is the distance from the center of the tap hole to the front/rear of the refrigerator?

Asked 6 days ago by homeseltzer.

Q: QuestionHello…I have this kegerator and I would like to add a C02 pressure gauge to the valve. Do you have a co2 pressure valve that is compatible.

Asked 1 week ago by Jason.

Q: QuestionWhat is the size of the gas line for the insignia kegorator (The ID and OD)?

Asked 3 weeks ago by Vince.

Q: Questionis the unit garage ready

Asked 1 month ago by jeff.

Q: QuestionCan the tap supplied be used with a corny keg? I have the corny keg connections ordered.

Asked 3 months ago by ChristopherF.

• A:Answer Thank you for your inquiry! Yes, the Insignia™ 5.6 Cu. Ft. 1-Tap Beverage Cooler Kegerator can be used with a Cornelius (corny) keg, but it requires a few modifications. The kegerator comes equipped with a standard D-system Sankey coupler, which is designed for commercial kegs and is not compatible with Corny kegs. However, since you’ve already ordered the appropriate Corny keg connections—such as ball-lock or pin-lock fittings—you’re on the right track. Once those arrive, you can replace the included coupler with your Corny keg connectors and ensure the CO₂ regulator and tubing are properly set up to match. With these adjustments, the kegerator will work just fine with your Corny keg setup.

  Answered 3 months ago by InsigniaCustomerSupport

  
  Helpful (0)Unhelpful (0)ReportAnswer this question

Q: QuestionDoes it hold all the following half barrell kegs? Corona, Stella, coors light , modelo

Asked 7 months ago by Woody.

• A:Answer Hi! Thank you for reaching out. You can fit the following keg sizes: 1/2 barrel, 1/4 barrel (short/pony), 1/4 barrel (slim), 1/6 barrel, and 1/8 barrel. For your reference, you can check the Quick Start Guide located on the features tab. I hope this information is helpful, and if you have any further questions, please feel free to ask! - Carl | Insignia Support

  Answered 7 months ago by InsigniaCustomerSupport

  
  Helpful (0)Unhelpful (0)ReportAnswer this question

Q: QuestionIf it had a cover (similar to a grill cover), can it be kept outside in South Florida?

Asked 7 months ago by beerdrinker.

• A:Answer Thank you for your inquiry! The Insignia™ 5.6 Cu. Ft. 1-Tap Beverage Cooler Kegerator is designed for indoor use and is not weatherproof. While using a cover similar to a grill cover might offer some protection, it may not be sufficient to protect the unit from the high humidity, rain, and temperature fluctuations typical of South Florida. Prolonged exposure to outdoor elements could potentially damage the kegerator's components and affect its performance. For optimal longevity and performance, it's best to keep the kegerator indoors or in a well-protected, climate-controlled area. Keith | Insignia Support

  Answered 7 months ago by InsigniaCustomerSupport

  
  Helpful (0)Unhelpful (0)ReportAnswer this question

Q: QuestionBought an Insignia home kegerlator model ns-bk17ss6. The tower doesnot fit. Whatb is the circumference of the tower. How do I get the correct tower

Asked 9 months ago by 12982Kedleston.

• A:Answer I'm sorry to hear that the tower doesn't fit your Insignia home kegerator. The standard circumference for the tower on the Insignia™ 5.6 Cu. Ft. 1-Tap Beverage Cooler Kegerator (model NS-BK17SS6) is approximately 6.28 inches (which corresponds to a diameter of about 2 inches). To get the correct tower, you can contact Insignia Customer Support at (877) 467-4289. They can help you find the right replacement part and provide further assistance. If you have any other questions or need more help, feel free to ask!

  Answered 9 months ago by InsigniaCustomerSupport

  
  Helpful (0)Unhelpful (0)ReportAnswer this question

Q: Questiondoes this come with CO2 tank and lines?

Asked 1 year ago by jk.

• A:Answer Thank you for your inquiry! Yes, the Insignia 5.6 Cu. Ft. 1-Tap Beverage Cooler Kegerator comes with a CO2 tank and the necessary lines. This includes a 5 Lb CO2 tank, which is essential for carbonating your beverages. Additionally, it comes with the hose and keg coupler, so you have everything you need to get started. Keith | Insignia Support https://www.bestbuy.com/site/insignia-5-6-cu-ft-1-tap-beverage-cooler-kegerator-stainless-steel/4223301.p?skuId=4223301

  Answered 1 year ago by InsigniaCustomerSupport

  
  Helpful (0)Unhelpful (0)ReportAnswer this question