1-9 of 9 Answers
Gf
Sorry, there was a problem. Please try again later.Yea you can, just pull it out easy and have someone holding it for you while you plug in the cable. I had to do the same thing
Sorry, there was a problem. Please try again later.Yes, pull down on the two strings. That releases the latches and it can tip off the wall.
Sorry, there was a problem. Please try again later.Pull both strings and swing the bottom away from the wall to access all connections.
Sorry, there was a problem. Please try again later.Yes. When you finish adding the new HDMI wire push the tabs up and click in the bottom of the bracket. However, being that the tv is close to the wall, you might want to check if the bracket will still lock in place. The head of the HDMI cable could prevent the bracket from locking. If so, purchase an HDMI cable with a right angle or swivel head.
Sorry, there was a problem. Please try again later.Yes, pulling those lines unlock the lower portions of the TV mount from the wall mount. Pull down both lines together and lightly pull bottom of TV away from wall until TV brackets clear wall mount. Now the mount is unlocked allowing you to tilt the TV up (pull the bottom of the TV away from the wall). DO NOT LIFT UP! when unlocked your TV is just hanging there on the wall like a picture. If you have a large TV they can be a little heavy. You might find something to wedge between the wall and the bottom of your TV, a old T-shirt works great, otherwise you'll have to hold the bottom of the TV out from the wall with one hand and install cables with the other.
Sorry, there was a problem. Please try again later.if you can't reach to put your hdmi cable you will need to take the tv off the mount and to do so you'll have to pull those two strings down. It would help if you did it with someones help, cause while ones pulls the strings down the other can push up and than down to take the tv off the mount. Hope this was helpfull.
Sorry, there was a problem. Please try again later.YES- if you pull the two strings it will release the TV from the bottom rail of the mount. You can then tilt the bottom out so you can connect your cable. Then just tilt the TV back and you should hear the latches snap in place and resecure.
Sorry, there was a problem. Please try again later.The manual for this Wall Mount is available at http://www.insigniaproducts.com/cms/documents/manuals/NS-TVMFP23_NS-TVMFP23-C_Manual_EN.pdf
Sorry, there was a problem. Please try again later.
