1-2 of 2 Answers
Depending on which stereo system you currently have it should be an easy install. But if you have the factory 10 speaker system it is just a bit more time consuming. You'll need to bypass your factory amplifier. Run new speaker wires from the new stereo to the amp location, and splice them into the factory speaker wires at the output side of the amp. When you replace the factory radio, you'll need to connect the wire in pin 3 of the factory harness to ground. This will prevent the factory alarm system from being triggered.
Sorry, there was a problem. Please try again later.I believe so!
Sorry, there was a problem. Please try again later.
