“How should I wire these 2 12 inch kenwood w120svc subs to my 2000 watt amp and what should I set my gain and stuff at?? Please help”
Answer This Question
1-2 of 2 Answers
You want to run your subs wired in series, this will raise the ohm rating of your amp making it safer for your 12 inch subs. I would start with your gain level at a quarter of its maximum gain level, turn up your system and listen closely to your subs, make sure they are producing clean bass, if they sound clean then try turning your gain up just a little more, if they start to pop instead of bump then you know to turn your gain back down, enjoy!
Sorry, there was a problem. Please try again later.Mount subs in box like normal. Take amp channel one positive to speaker one positive. Take amp channel two negative to speaker two negative. Take a jumper wire from speaker one negative to speaker two positive terminals.[connecting the last 2 open speaker terminals to each other] Don't know what amp you got so set it to half or a lil over. Set your crossover and stuff in car then you can crank amp if you think they can take it. You can also run the jumper wire in the box if you want,for looks ..hope this helps,should get you started anyways..good luck
Sorry, there was a problem. Please try again later.