A:AnswerI had the sub install in my Toyota FJ. My system includes a Sony XAV-5000 and a pair of 6.5”. 3.5” and tweeters with cross fade. Everything the installer needed to install the sub was in the box.
A:AnswerI had mine installed vertically on the rear seat in my Toyota FJ. It works fine. Have the installer run a little extra cable, just in case you lay the seat down.
A:AnswerI have no idea who that is, but I would guess you would need at least a 10" for an artist with that type of name. Sounds great for for Clutch and tool, but still no 10" and I am old
A:AnswerI don't see why not. You would just run the red power wire to your battery, attach the ground wire, and then tap into your speaker wires. I installed mine in a 2017 Jeep Wrangler. There's two ways to wire this. One is through your speakers, the other is with an aux adapter. You can connect to either the front or the rear speaker outputs of the radio. You will want to make sure the speaker wires you are connecting to do not have a high pass crossover that restricts bass response to the speaker they are connected to. If they do have a high pass crossover, you will need to select a different speaker source for connection. If you tap into the speaker wires, it eliminates the need for hooking up the blue remote power wire. You'll only use that if you choose to go the aux adapter route.
A:AnswerYour radio has rca's and also the amp can use speaker outputs. So yes it will work with your JVC. If you want to use the rca's you will need additional accessories to tie in to your head unit. KISL speaker wire to rca adapter. Good luck. Great bass is in your future.
