“Does this need anything additional to purchase for proper installation, and how difficult is it to self- install?”
Answer This Question
1-1 of 1 Answer
I'm somewhat handy and had no real problem installing this myself. I simply removed the old fan/light range hood and installed this microwave/convection oven in its place. I opted to use the default option of the recirculating fan instead of configuring an exterior vent so therefore I did not need to buy anything to install this that didn't already come in the box. The paper instructions have a template to locate holes for the top screws and the plug. This unit requires a 20A breaker, but luckily my outlet above the stove already had that. The top of the box is a template you use to very carefully locate where you will mount the rear bracket. You need to mount both ends of the bracket into the wall with drywall anchors if studs are not at those holes or just straight to the studs if your lucky enough that your studs do line up with the ends of the bracket. If you did use the drywall anchors at the ends, then you must find at least one hole in the bracket that is in front of a stud so that you can secure the bracket to at least one stud, preferably two. Once the bracket is in place, just roll the back edge of the oven onto it and then run screws through the upper cabinet down into the microwave to hold it into place. You may need a second pair of hands to help with this step because the oven is rather heavy to hold, roll onto the bracket, AND screw to the upper cabinet. You cannot let go until the upper screws are in place. -Dan
Sorry, there was a problem. Please try again later.