“Are there measurements/dimensions specifically for the downdraft? I see measurements for the overall unit, but not specific to the downdraft - just trying to figure out if it will line up with what I'm replacing (width/depth/offset from sides).”
Answer This Question
1-3 of 3 Answers
The cooktop comes with all new fan and motor so shouldn’t need to match up the dimensions to existing. You will most likely need new duct and high heat tape from hardware store to route the exhaust to your current exit. Hope that helps. I installed mine myself, was not that difficult. Might need two people, it’s heavy to lift in motor connected.
Sorry, there was a problem. Please try again later.Will this help you:
Sorry, there was a problem. Please try again later.Answer to your question on the downdraft. The overall measurement for the cook top is all you need. Ours was a perfect fit. My previous stove was the same size with a downdraft, so ended up getting a new one with bigger burners. The downdraft is part of the cooktop. The knob to turn on the downdraft is located along side the knobs for the stove. It has low and high setting. The down draft has a filter, which I remove and clean after every use. Hope I have answered your question.
Sorry, there was a problem. Please try again later.
