Questions & Answers
- Model:
- 1065957 R-100SW
- |
- SKU:
- 6241801
Page Showing 61-69 of 69 questions
Q: QuestionIf this sub is paired with Klipsch bookshelf speakers, would this sub overpower the bookshelf speakers? Will the bookshelf speakers still come through and sound crystal clear? And finally, would this be a good set up to pair the 2 together??
Asked by GoBucks.
- A:Answer The sub has a out put control so you can add just to your listening pleasure and yes they would make a good match.
Answered by Jake
Q: QuestionHello ,can i connect this subwoofer to my LG LHB755W home theater Thank you
Asked by griumpy.
- A:Answer Yes, you can connect this subwoofer to your LG LHB755W home theater.
Answered by CommunityAnswer
Q: QuestionDoes this have one plug that hooks up Into receiver instead of wires?
Asked by Danny.
- A:Answer Yes. Use a good quality gold tipped subwoofer cable to go from subwoofer line out In back of the receiver to the subwoofer line in Left in back of the Klipsch subwoofer speaker
Answered by Gamer
Q: QuestionHow good is this sub compared to the The klipsch R-110sw?
Asked by Moses.
- A:Answer It sounds better than this.
Answered by Jface1
Q: Questionwhy is there no best buy extended service plan offered on this sub?
Asked by Anonymous.
- A:Answer I purchased a Geek Squad Protection Plan for this item for $49.99. I did not purchase this item online. I purchased in the store.
Answered by BestBuyFan
Q: QuestionI have bose passive sub how do i hook up?
Asked by LL.
- A:Answer Hey LL, from my knowledge, normally on the rear of your sub there should be an input for your front speakers and an output for your passive satellite, tower or bookshelf speaker but also note, with this speaker configuration you will need two passive subwoofers, one each for the left and right channel.
Answered by SkinnaRock
Q: QuestionI have a sony std-dh590 receiver will the Reference Series 10" Subwoofer work with my receiver?
Asked by bedroomtv.
- A:Answer Absolutely. The Sony has 2 line level preamp outputs for subwoofers. Subwoffers require a line level signal from the receiver or PC. Refer to the attached image for the required cable (Male to Male RCA Jacks).
Answered by XSoundMixer
Q: QuestionI see that this has red-white inputs, and I was curious as to what connection cable I should use to hook this up to my receiver. I have a Yamaha rx-v485 receiver.
Asked by Patches.
- A:Answer if your Yamaha has 1 sub output then connect to the left rca plug on the sub. it is marked (LFE).
Answered by cutter28
Q: QuestionCan this sub work with an older Onkyo SR507 receiver?
Asked by Charger430.
- A:Answer Yes, as long as you have an RCA output
Answered by GeorgeS


























