“Would this washer/dryer combo stacked fit in a closet that has a depth of 32 3/4in? How much room is needed for installation?”
Answer This Question
1-2 of 2 Answers
I just measured mine. With the hoses in the back, mine measures 32 1/2 to the front of the washer door. I suppose I could get back and closer to the wall and gain 1/2 to 3/4" inches. Yours will be close but it COULD just fit if installed properly. If you purchase the matching steam dryer, don't forget the dryer has a cold water connection. Actually a "Y" fitting shares the cold water with the washer and runs to the dryer. Another consideration is your dryer vent. If it vents out the back and the 4" exhaust in the wall doesn't line up with the rear dryer vent hole, that will cause a problem fitting into 32 3/4" . My dryer vent aligns with the wall which is why it fits so close. If your dryer vents out the side you may not have a problem fitting into your depth.
Sorry, there was a problem. Please try again later.To ensure sufficient clearance for water lines, the drain line and airflow, allow minimum clearances of at least 1 inch (2.5 cm) at the sides and 4 inches (10 cm) behind the unit. Be sure to allow for wall, door, or floor moldings that may increase the required clearances. The WM3700HWA has the following dimensions: (WxHxD) 27" x 39" x 30 1/4". ^CP
Sorry, there was a problem. Please try again later.