A:Answer An IE fault on a top-load washer usually points to a water inlet issue rather than the way you load your towels. This error is triggered when the machine isn’t filling with water properly within the expected time. Here are a few professional troubleshooting steps you can try:
Check the water supply: Make sure both hot and cold water taps are fully open and that there’s adequate water pressure.
Inspect the inlet hoses: Look for kinks, twists, or blockages in the hoses connected to the washer.
Clean the inlet filters: Most washers have small mesh filters inside the hose connections—if these are clogged with mineral deposits or debris, the water flow will be restricted.
Test different cycles: Run a quick wash or rinse-only cycle to see if the error appears consistently across all programs.
Reset the machine: Unplug the washer for a few minutes, then restart it to clear any temporary error codes.
If the problem persists after these checks, the issue may be with the water inlet valve or a sensor, which would require professional servicing. Source: https://washingmachinemanuals.com/
