“Does the installation team change the breaker switch if the correct one is not already installed?for a hard wired range installation?”
Answer This Question
1-2 of 2 Answers
The LG 6.3 Cu. Ft. Freestanding Single Electric Range with EasyClean and WideView Window - Stainless Steel, Model # LREL6321S requires a single-phase, 3-wire, A.C 120/208V or 120/240V 60Hz electrical system. Use only a 3-conductor or a 4-conductor UL-listed range cord with closed-loop terminals, open-end spade lugs with upturned ends or similar termination. Do not install the power cord without a strain relief. A range cord rated at 40 amps with 120/240 minimum volt range is required. If a 50-amp range cord is used, it should be marked for use with 1 3/8" diameter connection openings. This appliance may be connected by means of a conduit or power cord. You must purchase a new power cord for your new electric range. New electric ranges do not come with a cord. Existing power cords cannot be reused. Please call -888-BEST BUY (1-888-237-8289) or contact your store to inquire if Best Buy installers are licensed or authorized to change your circuit breaker board if the correct one is not installed. If they are, and if necessary, the installer will obtain any necessary permits and you are responsible for the cost of any such permits...^IFV
Sorry, there was a problem. Please try again later.unless the installer is a qualified electrician you do not want them anywhere near your service panel. its one thing to attach a power cable to a dead appliance then plug it in. its another to work with live electricity in a box
Sorry, there was a problem. Please try again later.
