1-1 of 1 Answer
Use only 4-inch (10.2 cm) rigid, semi-rigid or flexible metal ductwork inside the dryer cabinet and for venting outside. The dryer has its own terminal block that must be connected to a separate 240VAC, 60-Hertz, single-phase circuit, fused at 30 amperes (the circuit must be fused on both sides of the line). Electrical service for the dryer should be of the maximum rate voltage listed on the nameplate. Do not connect the dryer to 110, 115, or 120-volt circuit. ^Daphane
Sorry, there was a problem. Please try again later.