1-2 of 2 Answers
Which cycle did you just run on the LG STUDIO 24" Top Control Smart Wi-Fi Dishwasher - QuadWash - TrueSteam -Steel Tub with Light - Stainless Steel, Model # LSDT9908ST and did you leave the dishes to dry overnight? When dishes are often left overnight after the cycle ends, the steam inside the tub can condense on the dishes leaving them wet. The Night Dry option runs the ventilation fan periodically to help vent the steam from the tub. It is is selected by default on all cycles for which it is available, except the Normal cycle. If you ran the dishes in the Normal cycle, to add the Night Dry option to the Normal cycle, press and hold Extra Dry for 3 seconds. Rinse aid helps to ensure that the majority of the water has been sheeted off of the dishes at the end of the rinse and that the load is ready for the dry cycle. The cloudy film on your dishes after the wash is usually caused by minerals in the water reacting with the dishwasher detergent. First, be certain not to use too much detergent. Refer to Adding Detergent to the Dispenser section for recommended detergent amounts. Add an extra rinse to the cycle. LG Dishwashers use less water than traditional dishwashers, so adding an extra rinse aids in rinsing the film away. If the water supply is hard, it may be necessary to add a performance booster that addresses the hard water condition. Water tends to bead rather than sheet off plastic and nonstick surfaces, making them more difficult to dry. If washing plastic items in a Normal cycle, select the Extra Dry or Night Dry option or both for better drying results. When the rinse aid is empty, the Extra Dry option is selected automatically. Allow the dishwasher to completely finish the dry cycle before opening the door. If the door is opened in the middle of the dry cycle, the heat that is necessary for the hybrid dry system to work will escape. This will cause all of the dishes inside to remain wet once the cycle finishes...^IFV
Sorry, there was a problem. Please try again later.Put it on dual zone
Sorry, there was a problem. Please try again later.