“Does this support 2.5gb fiber optic or does it only support up to a max of 1gb?”

1-3 of 3 Answers

• These ports at 1G Copper RJ45, you will need a switch that supports 2.5G. With that said 2.5G is an interim port speed, better off going straight to 10G Copper RJ45. You can find low cost 8-Port 10G switch for ~$500. Single Mode Fiber/SMF is Layer1, you can run anything over that, even 10M Ethernet. SMF infrastructure was developed to suppress electrical interference, and longer cable runs, as copper is limited to 300F. SMF is limited to 40km.

  Answered by ichbineinnerd 2 years ago

  • Verified Purchase
  • 

  Helpful (0)Unhelpful (0)

  Report

  Sorry, there was a problem. Please try again later.

• the device will connect to a 2.5 GB fiber without issue, but will only communicate at its own design speed of 1GB.

  Answered by HelpDesk180 2 years ago

  • Verified Purchase
  • 

  Helpful (0)Unhelpful (0)

  Report

  Sorry, there was a problem. Please try again later.

• The SE3008 switch supports up to 1 gigabit speed only, ConcernedGamer.

  Answered by Linksys Staff 3 years ago

  Helpful (0)Unhelpful (0)

  Report

  Sorry, there was a problem. Please try again later.