“What gauge is the cable for the IR blaster that plugs in the back? That is, what is the diameter or circumference of the cable? What is the length of the cable?”
Answer This Question
1-5 of 5 Answers
It looks like my IR blaster is about a 18 to 20 gauge wire and the length is 6 feet.
Sorry, there was a problem. Please try again later.The lengths are about 4 - 5 ft.... the plug in type is 3.5
Sorry, there was a problem. Please try again later.The cable is about 7 to 7.5 feet long (mine is installed so it's hard to measure exactly). The diameter of the cable is almost exactly 2mm. (Note: older Logitech Harmony remote IR cables do not fit the connector on this new Harmony Hub.)
Sorry, there was a problem. Please try again later.It's a 2.5mm jack. Not sure what the actual gage of the cable is, maybe 16. It's 10 ft long.
Sorry, there was a problem. Please try again later.Can't tell the actual wire gauge without cutting and stripping the insulation, but the wire is about 1.5 mm. It is 8 feet long.
Sorry, there was a problem. Please try again later.