“Is this compatible with Dish Network's receiver # R1898725879 (Hopper with Sling)?”

1-10 of 11 Answers

• yes it is

  Answered by patrice2 11 years ago

  Helpful (3)Unhelpful (0)

  Report

  Sorry, there was a problem. Please try again later.

• Yes

  Answered by Crispy1234 11 years ago

  Helpful (1)Unhelpful (0)

  Report

  Sorry, there was a problem. Please try again later.

• Yes.

  Answered by lysa 10 years ago

  Helpful (0)Unhelpful (0)

  Report

  Sorry, there was a problem. Please try again later.

• Yes

  Answered by Mrautomation 10 years ago

  Helpful (0)Unhelpful (0)

  Report

  Sorry, there was a problem. Please try again later.

• Yes. All Dish, Direct and Time Warner are compatible. If it has a remote, or connected to the same router, the Harmony can control it. Harmony constantly updates the remote database and that's the advantage of this device, it will always be updated and supported. At first it was almost annoying all of the updates but I "sync" one a week now to stay ahead.

  Answered by PLupi 10 years ago

  Helpful (0)Unhelpful (0)

  Report

  Sorry, there was a problem. Please try again later.

• Yeppers!

  Answered by Diego7979 10 years ago

  Helpful (0)Unhelpful (0)

  Report

  Sorry, there was a problem. Please try again later.

• It should. I looked up that device using their device compatibility page: http://support.myharmony.com/en/compatibility?utm_source=logitech.com&utm_medium=pdp&utm_campaign=compatibility%20lookup

  Answered by hereticmonkey 10 years ago

  Helpful (0)Unhelpful (0)

  Report

  Sorry, there was a problem. Please try again later.

• Yes works very well

  Answered by livvyluv 10 years ago

  Helpful (0)Unhelpful (0)

  Report

  Sorry, there was a problem. Please try again later.

• Yes it works

  Answered by karore 10 years ago

  Helpful (0)Unhelpful (0)

  Report

  Sorry, there was a problem. Please try again later.

• Yes. All harmony remotes are compatible with the hopper. I have used multiple versions with hoppers without problem. You have to set the hopper to accept IR mode, and that's all there is to it, other than programming the remote.

  Answered by PoDuck 11 years ago

  Helpful (0)Unhelpful (0)

  Report

  Sorry, there was a problem. Please try again later.