“I have a Audio-Technica 120 turntable. There is one cable coming out of the back that has one red and one white male plug. What will I need to connect these speakers to turntable.”

1-5 of 5 Answers

• You'll need a stereo pre-amp or a stereo receiver with a specific Phono input.

  Answered by chrizens 9 years ago

  Helpful (0)Unhelpful (1)

  Report

  Sorry, there was a problem. Please try again later.

• Typically you will need an audio receiver with either phono jacks or a powered aux input on the back of the receiver. If you do this be sure to switch the turntable preamp to off (if model comes with on/off for preamp on turntable. The speakers are connected to the receiver speaker inputs.

  Answered by Tapes 9 years ago

  Helpful (0)Unhelpful (1)

  Report

  Sorry, there was a problem. Please try again later.

• You need an amp between turntable and speakers.

  Answered by electronman 9 years ago

  Helpful (0)Unhelpful (1)

  Report

  Sorry, there was a problem. Please try again later.

• The cable coming from your turntable plugs into an amplifier or pre-amp. Speaker wire runs from the amp to the speaker. You need an amp/pre-amp to connect these speakers to your turntable.

  Answered by Elementary 9 years ago

  Helpful (0)Unhelpful (1)

  Report

  Sorry, there was a problem. Please try again later.

• You probably need an amp to connect to the turntable and speakers too. Check out YouTube for many tutorials with that turntable

  Answered by ELStav8 9 years ago

  Helpful (0)Unhelpful (2)

  Report

  Sorry, there was a problem. Please try again later.