“My doorbell sits in a very narrow spot. One side of the doorbell the front door closes and the other side extends out. Is there a model that would work? I cannot upload the picture.”
Answer This Question
1-4 of 4 Answers
I re ran my doorbell wires from the door frame to a 7/8" inch hole i drilled in the brick and mounted it fine, you can make it smaller by not using the trim plate that i have used. I hope the picture i posted gives any kind of help in your decision.
Sorry, there was a problem. Please try again later.They make wedges that sit at different angles you can install behind the doorbell. This will hold your camera at an angle where you can view better
Sorry, there was a problem. Please try again later.Hi Henrythecat, Thanks for reaching out. In order to assist you further, I would like to connect with you directly. Would you please email me directly at [email protected]? I would appreciate your time. Kaitlyn R., Neighbor Satisfaction Specialist [email protected]
Sorry, there was a problem. Please try again later.If its too narrow, i don't think it will fit but you can give a try.
Sorry, there was a problem. Please try again later.
