A:AnswerYes, a sound bar may be mounted to swivel stand; actually it's connected also to the bottom of the TV as far as I can see right now . I am enjoying my new TV and attached sound bar right now. It is mounted on the wall above the fireplace, so the soundbar does not have to take up space on the mantle.
A:AnswerThey will bring a template you can place on wall to find center that matches stud spacing. Geek Squad did an outstanding job on my install despite odd stud spacing caused by shower installation on opposite side of wall.
A:AnswerIn general, I would say that it can be mounted on brick. *It all depends* Take into account the brick; it's condition, size, etc.. Yes, there’s special requirements such as the right anchors, drill bits, etc.. * dont drill into the mortar*
A:AnswerHello,
A 65" TV should have about 57 degrees of swivel movement to the left or right with this mount. Yes the TV attachment has about 21in of left or right adjustability on the wall plate.
Thanks,
Nate @ SANUS
A:AnswerHi Mark,
Yes, I'd recommend the SANUS - "WSSATM1". It is an extendable sound bar TV mount that is designed for the Sonos Arc sound bar. It attaches to the back of your TV and features 5" of depth adjustment to ensure mics and Atmos drivers are clear and working properly. If you have any questions about the mount feel free to give us a shout at [email protected] or 1-800-359-5520. We're happy to help!
Thanks,
Nate @ SANUS
A:AnswerHello, This mount should be compatible with your TV. The TV has a 200 x 200 VESA pattern and weighs 18lbs. Which means the screen size, weight and VESA pattern all fall within the compatibility range of this mount. If you have any other questions give us a shout at [email protected] or 1-800-359-5520. Thanks, Nate @ SANUS
A:AnswerHello,
This mount should be compatible with your TV. The TV has a 200 x 200 VESA pattern and weighs 22lbs. Which means the screen size, weight and VESA pattern all fall within the compatibility range of this mount. If you have any other questions give us a shout at [email protected] or 1-800-359-5520.
Thanks,
Nate @ SANUS
A:AnswerSanus dose make a mount to use with there tv mount. I purchased a mount on line for my beam and hooked it to my previous mount. With the Sanus mount it would not work because it had no mounting holes at all. So I used the 4 holes from my tv stand to hold the bracket. You just need to buy some longer matching small bolts. Mine were 4mil metric.
A:AnswerHello, The tension knob directions are on page 12 of the instruction manual, under the section titled "Tilt Adjustment". Use the provided hex key to to tighten or loosen the knob. If you have any questions you can call 1-800-359-5520 for installation help.
Thanks,
Nate @ SANUS
