“How big of a hole needs to cut through the back of the cabinets to run the hose? Does Best Buy do the cut outs for that in a recently remodeled kitchen?”
Answer This Question
1-7 of 7 Answers
The hole needs to be at least 1" diameter to get the fitting through. 1 1/4 or 1 1/12 would be better. I didn't use Best Buy's service for the installation. If you have a drill and a 1/1/4" drill bit, you can make the hole yourself. Hooking up the line is not hard - especially if you find You-Tube videos. They help a lot.
Sorry, there was a problem. Please try again later.They can do custom work but there will be an additional fee. Probably less than $100.
Sorry, there was a problem. Please try again later.I would say if you did and inch or two you should be fine.
Sorry, there was a problem. Please try again later.Hello , i had Best Buy replace my old dishwasher so the hole was there , however since the hose is a 1/2 , I would cut a 3/4 opening
Sorry, there was a problem. Please try again later.I used a 1/2" bit to made the hole. it was just right but I widen it up a bit more with the 1/2" so it easier to push through. You can always use silicon to cover around the hole. Best Buy does the cuts but they will need your permission as long as they have easy access to the rear of the cabinets.
I would recommend:
Sorry, there was a problem. Please try again later.One to one and half inch. Hose dimension is available on line
Sorry, there was a problem. Please try again later.No there is a place ready for it in the back.
Sorry, there was a problem. Please try again later.
