“PLEASE ADVISE How to Connect this system for a mono speaker I am planning to use this system to feed music in a coomercicial set up, where each one of the 4 rooms have 1 ceiling speaker. How can I connect the speakers ? Left Side out put ? Right Side output ? or Maybe connect the left and right sides to the same speaker wire using a jumper piece of additional wire ? I am concerned that if I connect only to one side, I might miss out on certain parts of the music that were being output from the other side. PLEASE ADVISE”
Answer This Question
1-3 of 3 Answers
Mix or parallel the stereo source down to a mono signal to supply both the right and left input of the amp the same mono audio. Then connect the speakers normally as you would for a stereo installation. Because the right input is the same as the left input all speakers get the same music.
Sorry, there was a problem. Please try again later.radio shack used to make a stereo to mono cord. -try amazon
Sorry, there was a problem. Please try again later.Hi Paul, This Sony receiver only have 2 sets of speakers( A and B). You can’t use this in your 4 rooms. You will need additional device to cover the other 2 rooms. –Joffrey
Sorry, there was a problem. Please try again later.