“WF210 and DV210 with SK-5A/XAA stacking kit The stacking kit is installed, but the holes on the bottom rear of the dryer are not lining up with the holes in the brackets installed on the washer. See attached pics. Img_1 has the dryer slid all the way back and Img_2 has the dryer slid forward so that you can see the screw holes not lining up. I followed the installation instructions which were straightforward. I don't see where I could have made a mistake, but I guess it is possible.”
1-1 of 1 Answer
Thank you for the question. Your pictures show that you are on the right track in following the instructions for installing the SK-5A stacking kit. It is sometimes necessary to maneuver the dryer by lifting it so the holes do align. Once installed, the weight of the dryer and the tension created by the pressure of the dryer on the bracket will help to keep the dryer in place. One suggestion I've found helpful in aligning the bracket with the holes is to attach the screws to the back of the dryer first, before the washer. Then you may need to have someone lift the back of the dryer slightly to enable you to align the bracket holes with the back of the washer. If you wait until all screws are started before tightening any of them, you'll have an easier time. Please call 800-SAMSUNG to speak with an agent if you need further assistance. - Ms. Samsung
Sorry, there was a problem. Please try again later.