“How do I remove the cases rom my iPad? I've just purchased this case for my iPad mini 2 and fitted it without removing the plastic wrapper therefore cannot charge. How do I remove this case??”
Answer This Question
1-10 of 10 Answers
Two options A: If you can gently push off both corners do it non harmfully with your hand most notably your thumb and then two fingers on the other side of the corner, B: If option A fails grab a towel and then push down on the corners as hard as possible, use the towel as a barrier between your fingers and the ipad as pushing hard without it is painful (try to do over a bed as you might fling the iPad in the process) If you cant get it off in the first minute just move onto option B if you see no success Option A only works if you know you can bend the cover and its flexible I recommend Targus covers not only are they easy to remove they offer a much longer lasting resistance to the ipad. I have had mine for 5 years with a Targus cover and without any noticeable screen shattering
I would recommend:
Sorry, there was a problem. Please try again later.Gently pop off the two corner holds by where the front cover hinges, then slide the iPad out of the middle fingers towards the front flap.
Sorry, there was a problem. Please try again later.Take it off
Sorry, there was a problem. Please try again later.How do you remove a OtterBox from a iPad 10
Sorry, there was a problem. Please try again later.I just bend back the corners til it pops out. The fact that the IPad doesn't come out easily is a good thing for a case.
Sorry, there was a problem. Please try again later.It's tough to remove and it feels like it might break but it shouldn't. However, if it does break, contact the manufacturer because they do a good job of taking care of their customer's needs.
Sorry, there was a problem. Please try again later.The corners are bendable. You should be able to remove and reinsert your Ipad by slightly carefully bending them out and then back in. Hope this helps!
Sorry, there was a problem. Please try again later.Pinch down from any corner to loosen the cover.
Sorry, there was a problem. Please try again later.Just the reverse of the way you put it in. It virtually pops out on the bottom two corner clips and then slides out of the upper part.
Sorry, there was a problem. Please try again later.Cut out the plastic from the charging port.
Sorry, there was a problem. Please try again later.
