“How do I turn off the "end cycle" chime/beeping? The manual has no mention of it.”
Answer This Question
1-2 of 2 Answers
Hi CB1234, thanks for your question. Please see the following instructions to turn off the end-of-cycle signal for model DWHD650WFM. 1) Turn on the dishwasher 2) Press and hold the ‘setup 3 sec’ button for 3 seconds until H:0X (x can be any number) is shown on the display window. 3) Press and release the ‘setup 3 sec’ button until SL:0X (SL is for Signal Volume at the end of a program) appears on the display. 4) Use the + or – buttons to change the setting to SL:00. This will turn the volume off. 5) Press and hold the ‘setup 3 sec’ button for 3 seconds to save this setting. For additional information on each of the settings, please refer to page 10 of the Use & Care manual. Thank you!
Sorry, there was a problem. Please try again later.Change the setting as follows: 1. Open the door. 2. Press the ON/OFF button. 3. Press and hold the "setup 3sec" button for 3 seconds until H:0 is shown on the display window 4. Press the "setup 3sec" button to access the individual settings. 5. Adjust the setting using the + and - buttons. 6. Press and hold the "setup 3sec" button for 3 seconds. The chosen setting has now been stored. Note: If you want to change several settings, first make all your changes one after the other. Then press the ‹button for 3 seconds. All the settings will then be stored in the dishwasher. Cycle thru the adjustable settings till you get to SL. SL– Signal volume Adjust SL:00 thru SL: 03 This is the volume of the signal at the end of a program. SL:00 is no sound. This is in the manual.
Sorry, there was a problem. Please try again later.