1-9 of 9 Answers
No they can’t be cut. They are separated into 200 light bundles each. So the plug is in the middle of the set. The Twinkly Dots are one long string with about three feet of wire for the USB connection.
Sorry, there was a problem. Please try again later.Hi! The 400 LEDs strings have a lighted length of 32 metres/ 105 ft and are divided into two strings of 16 metres/ 52.5 ft. The 60 LEDs Dots come instead a single string. As far as do-it-yourself modifications on strings are concerned, we always advise against them because they invalidate the warranty! Hope these info would help you!
Sorry, there was a problem. Please try again later.The 400 LEDs are split between two separate 200 light strings, joined to the same controller. The Dots are a single RGB strip. I wouldn't recommend cutting them, as they're all set up to be individually addressable. The controller might not react well to any modifications to the wiring.
Sorry, there was a problem. Please try again later.Yes, two separate strings (400 and 60) with individual control through the app. No...you can't cut them.
Sorry, there was a problem. Please try again later.Not sure if you can cut the 60. I got the 400+90. The 400 is 1 box ans splits into 2 strands of lights. I split them into 2 different xmas trees and they were programmed with app and phone camera so it recognized the 2 different trees and can fully customize brightness, volor, patern and even timer
Sorry, there was a problem. Please try again later.The 400 is actually two separate strings connected to same controller. Cutting either would not be as easy a task as typical tape leds
Sorry, there was a problem. Please try again later.They are two strands. No they can not be cut. Powered by plug in and usb for the 60 dots.
Sorry, there was a problem. Please try again later.400 are on one string that are split into two sections. Neither can be cut
Sorry, there was a problem. Please try again later.There are two light strings in the box. One 400 light string and one 60 light string of ‘dots’
Sorry, there was a problem. Please try again later.
