A:Answer I actually asked this question, but got no answer until I had all 3 items in my possession. The Brydge keyboard hinges will fit the Apple iPad, but not with the UAG case attached to the iPad. The molding on the bottom edge of the case, that allows the iPad to snap into place, wraps too far around the bottom to allow the hinges to slide onto the iPad. Ironically, the hinges have notches which look like they were designed to slide inside the molding, but the notch on the hinge is on the inside of the hinge instead of the outside where it would have to be to slide past the molding. (Did some engineer go to sleep on the job ?). I'm tempted to take a fine tooth hacksaw and carefully remove 1/4 of an inch of the molding from each side of the case so the hinges will have enough clearance to slide onto the iPad.
