“Sender unit wont turn on, just bilnks once, then goes off I have tried holding the power button down, it blinks while the power button is held down and then goes off when the power button is no longer pressed.”
Answer This Question
1-1 of 1 Answer
Make sure that the power cords are connected correctly. • After the power buttons have been pressed to turn on both the sender and receiver, the front panel LEDs should light. If they are solidly on, a communication link has been successfully established between the units. If they are flashing on one or both units, press and hold the CONNECT button on either the sender or receiver for two seconds. (The sender's CONNECT button is on the bottom and the receiver's CONNECT button is on the back panel.) This will put the unit into the “connection mode” for about 30 seconds. During this period the CONNECT button on the other unit must also be pressed for two seconds so that it will also enter “connection mode.” The system proceeds with the connection process between the sender and receiver. While in “connection mode,” the LED indicators blink at a faster rate. When an active link is established between the sender and receiver, the LED indicators will be solid on and will not blink. Note: Try pressing the CONNECT buttons again if the LED indicators keep blinking after 30 seconds.
Sorry, there was a problem. Please try again later.