A:AnswerI added two more Vizio surround sound speakers from my old SB4051 Vizio purchase a three-way RCA one male and two female I used FosPower 8 in qty 2 because shielding around plug is thin at input so it will fit in elevate speaker. And purchase two J&D 3ft 2male to 2female and just pull them apart and use one for each speaker going to Atmos side of speaker in Vizio I did a test with the remote first to know which side was Atmos input I believe it is the right input.Then you could use any RCA lying around to tap in off of y adapter female to run your other speaker I have mine about 5 ft away midway towards front in my living room from rear speakers They work great and I did a lot of research I've had it cranked and haven't blown anything yet The amps they put in the subwoofer can handle it. I felt I was safe with the Vizio speakers I had although they do not say the ohms but during my research I think it would be better to stick with four ohms instead of 8 ohms if you have other speakers lying around it'd be worth a try even if you had 8 ohms gives that added sound with music. Just took me a month with this soundbar to figure out. Turn off virtual x on your remote it distorted the center channel on the bar and makes it lower sound. That's only used if you're wanting to run two channel stereo enhance the sound to the back speakers. The y adapters just to know they are uni directional so the way I hooked it up worked. I believe this system has 18 total speakers now I have 20. Just write a diagram down before you do and you'll see how you'll want to run everything. Just tap in all cables from the Vizio proprietary male plugin Good luck.
A:AnswerTo answer your question, I want to gather a bit more information. When you have a free moment, we are available through text message, chat, or over the phone. Just go to support.VIZIO.com and click on ‘Contact Us’.
A:AnswerHey Jimmyz,
Rather than measuring in watts which is just a measurement of power draw, we focus on dB or sound pressure level. The Elevate soundbar can reach 107dB sound pressure level and 30Hz – 20kHz frequency range for dynamic and accurate sound.
