“HOW CAN I CONNECT THE IS6200 HEADSET TO THE DS6251-2 PHONE”
Answer This Question
1-2 of 2 Answers
In the event someone has the same difficulties deregistering and registering their IS6200 headset when the base is not longer working or available, and registering to a newer compatible VTec Answering Base (ours is the CS5229-2), I fiddled a bit and discovered the following: 1) DEREGISTER: sequence these 1) Vol+, On 2) Vol-, On 3) Vol+ 4) Vol-, On (Headset starts a slow flash red/blue, might also beep) 2) REGISTER: To a new base that is different than original;y used...discovered on the CS5229 that trying to register Headsets AFTER the Handsets wasn't allowing the Headsets to register regardless what I tried, but eventually stumbled onto this sequence: START WITH HEADSETS Start registering procedure by deregistering all handsets and headsets...usually by holding the FIND HANDSET button down until it flashes, then immediately press it again, it'll beep, wait 10 seconds or so for all handsets to deregister, then... - Set slow flash red/blue Headset into charging stand (starts to fast flash red/blue) - THEN (this is the odd part but it worked) PLACE ONE Handset into the base, wait for Headset light to turn solid red - Remove Handset from base (to keep it from registering) - Repeat for other headsets Then... - Register other Handsets per instructions (by placing each one in the Base sequentially (usually up to five total headset/handsets) NOTE: For one Headset this will number the first Handset not as #1 but as #2...or #3 for 2 Headsets, etc.
Sorry, there was a problem. Please try again later.Julie - We are sorry if you are having problems registering the headset. Here's the complete instructions on how you can register your VTech IS6200 headset on the DS6251: Step 1: Press and hold /FIND HANDSET on the telephone base for about four seconds until the red IN USE light turns on. Then, release the button. Step 2: Place the headset in the headset charger immediately. It takes about 60 seconds to complete the registration process. The red IN USE light on the telephone base turns off. The ON/OFF light on the headset turns red when it is registered and charged. Step 3: Lift the headset, then press ON/OFF key on the headset. If you hear a dial tone, the registration was successful. Hope this helps! -VTech Support
Sorry, there was a problem. Please try again later.