1-1 of 1 Answer
Hello! General Instructions for Door Reversal: You will need a flathead screwdriver and usually both 5/16th and 1/4" Hexhead to remove the screws on this product. To reverse the dryer door the hinges will need to be removed from the chassis of the product and the door with the 4 screws that hold them. Once removed the hinges can be mounted immediately to the otherside of the chassis. The strike on the chassis of the product will need to be removed with the screw and moved over to the other side. The catch on the door is a clip retainer, with a flathead (or pliers) you can squeeze the catch together and remove it. This too will move moved to the other side of the door. The final steps will require the door to remain dismounted from the product. Several screws lie around the top, bottom and sides of the door that can be removed to separate the door paneling into two. The outer panel (facing outward from the product if it were mounted) must be flipped 180° and resecured so that the door handle is on the other side. Finally the door can be remounted to the hinges and checked for alignment.
Sorry, there was a problem. Please try again later.