“filter #3 fits in bottom of fridge. Does it fit flush? It sticks out about 1/3".”
Answer This Question
1-8 of 8 Answers
fits flush.
Sorry, there was a problem. Please try again later.Mine has a slot to fit into. You have to make sure the two prongs sticking out fit into the holes at the back of the slot properly. You have to push it really hard, until it makes a whooshing noise as it connects with the water system.
Sorry, there was a problem. Please try again later.It fits into the space correctly, but you need to remove the cover from the old one and put it in this one. It is this cover, along with the eject button next to it, that helps you remove and put it back in. Without it I can be a bear to remove.
Sorry, there was a problem. Please try again later.This filter doesn’t protrude from the refrigerator.
Sorry, there was a problem. Please try again later.In my refrigerator it is slightly inset. It does not stick out. If yours is sticking out, it may not be installed correctly. Check your manual.
Sorry, there was a problem. Please try again later.It should fit in all the way. Make sure you twist filter as you push it in. It should fit then.
Sorry, there was a problem. Please try again later.Flush
Sorry, there was a problem. Please try again later.Ours fits perfectly. There's a cover over it and you don't see it at all. If it fits correctly it shouldn't stick out.
Sorry, there was a problem. Please try again later.