“Can the vent (where the duct goes) hole be cut out on top more to the right?”
Answer This Question
1-1 of 1 Answer
Hello, please refer to page 10 of the Use and Care Manual for Mounting Height, Clearance, & Ducting instructions. A minimum of 7” round for AK25 or 3-1/4” x 10” rectangular duct must be used to maintain maximum air flow efficiency for vertical ducting. For horizontal ducting, 3-1/4” x 10” rectangular duct is the minimum size. Thank you for your inquiry! -Zephyr
Sorry, there was a problem. Please try again later.