Enjoy your treasured vinyls with this Audio-Technica automatic wireless belt-drive turntable. Bluetooth connectivity enables pairing with wireless speakers and headphones, and the included RCA cable provides compatibility with wired components. This two-speed Audio-Technica automatic wireless belt-drive turntable plays 33-1/3 RPM records and comes with a 45 RPM adapter to accommodate singles.
Q: Can i go for a run with this in hand??
A: I wouldn't recommend it. If you trip and fall, you will scratch your vinyl.
A: It does not have its own speaker. At this time all of our turntables have to be connected to an external speaker in some way. The simplest and most cost-effective way to use the AT-LP60-BT Wireless turntable is to pair it to a Bluetooth speaker or Bluetooth headphone, or to hard-wire it to a pair of self-powered (aka active) speakers or headphone amplifier and headphones.
Q: Can this player be used to create digital versions of your vinyl on a computer hard drive?
A: Yes, by using the 3.5 mm stereo Analog Out jack on the rear of the turntable, it is possible to connect the turntable to the LINE IN jack on a computer. Note that the audio cable provided with the turntable is a 3.5 mm male stereo to dual RCA male type cable. You will need either an adapter cable, the dual RCA female to 3.5 mm male stereo type, or a different cable all together - the 3.5 mm male stereo to 3.5 mm male stereo type, to connect the turntable to the computers LINE IN jack. Make certain that you set the preamp selector switch located on the rear of the turntable to the LINE position and select the LINE IN jack on the computer as the input device.
A: Thank you for your inquiry. Yes, it includes the stylus.
Q: Does this model contain a built-in preamp?
A: It does and the preamp can be switched off.
A: You can just plug it into power and pair it to a Bluetooth speaker. There is also a wired connection that permits the turntable to be connected to a powered speaker that may not feature Bluetooth.
A: The cartridge is an integral part of the tonearm. The stylus is included and comes installed on the cartridge. The drive belt comes preinstalled around the aluminum record platter, you must finish installing the belt by placing it around the brass colored motor pulley after placing the platter on the center spindle.
Q: Will this player play all record sizes (7", 10 and 12)?
A: In AUTO mode you can play 7 and 12 inch records, use the MANUAL mode to play 10 inch records.