“Would I be able to run (2) Point of Sale registers on one UPS? Or would I need one for each register.”
Answer This Question
1-3 of 3 Answers
It could, but I would not recommend it. The last thing you want to do is have both point of sale PCs go down at the same time if the UPS fails. Buy two UPS units as they are not that expensive compared to potential lost sales.
Sorry, there was a problem. Please try again later.Most likely assuming your total power draw (total number of watts consumed) by your 2 Point of Sale registers are not above the maximum output rating for this device. But you also need to factor in how long you wish to power your Point of Sale registers when the power is out. The lighter the wattage consumed the longer it will power your machines. So it is a compromise between how many uninteruptable power supplies you want to purchase with how long you wish to run them during a power outage. As long as you do not go over full rated power of the battery back up it will run as many devices you would like, just not as long as if a smaller total amount of power was consumed. Make sense?
Sorry, there was a problem. Please try again later.Thank you for your inquiry. You would likely need two UPSs for the registers but it would depend on how much power the registers pull. The BN900M would support 480 watts of equipment connected to it so I would verify how much power the registers draw. If they were to draw over the supported amount the UPS would become overloaded and stop providing power to the equipment. Please do not hesitate to reach out to an APCbySchneider sales team for further assistance if you require it. We offer email and chat services through our support site and you may also contact us directly at 800-800-4272.
Sorry, there was a problem. Please try again later.