“We need to replace our Bosch custom panel dishwasher. It has two pieces to the custom panel and the repair tech said to make sure the new model wiill accept a two piece panel. Does this model accept two piece custom panels? Old model is SHV46CO3UC/14.”
Answer This Question
1-2 of 2 Answers
The panel is attached by screws on far sides of door. If your panels each are full width, then screws can be screwed in, even if you need to add a couple of holes. If they don't reach edges to the left and right, you could buy a thin piece of plywood, cut to full front door measurements and attach to plywood first. If you do this, you may need to move dishwasher further back by the width of plywood. Would suggest thinnest plywood if you need to go this route. Always make sense if you are not handy with wood to have a knowledgeable person look at for you.
Sorry, there was a problem. Please try again later.The installation instructions don't specify whether the dishwasher can accept 2 piece panels. They cover width (up to 24 inches), thickness (3/4 inch) and weight which varies depending upon the panel. The dishwasher is configured to accept panels weighing from 11 to 18 pounds, but if you have a heavier panel, you can check with Bosch to find out how the dishwasher can accommodate a panel up to 24 pounds.
Sorry, there was a problem. Please try again later.
