“Can I put 32GB 3600mhz Vengeance Pro RAM in this Asus motherboard without damaging it? Will it just run at 3200mhz?”
Answer This Question
1-6 of 6 Answers
I installed 64Gb (4x16) of Trident Z RGB F4-3600C16D-GTZR Ensure you turn on D.O.C.P in Bios and on the front BIOS page where it says Normal mode I Changed to optimized Had to install one stick at a time starting with B2 or the second slot, then the 4th, back to the 1st and lastly the 43rd position, restarting the machine each time so that they are recognized correctly.. You will see the slot listings on the x570 Board -2 have stars above them and you start with them. Checking Task info (CTRL +Shift+ESC) each time ensurees they are being seen as 3600Mhz as does CPU ID / CPU Z
Sorry, there was a problem. Please try again later.I installed Corsair Vengeance RGB Pro 128GB 4x32GB DDR4-3600 Memory RAM CMW128GX4M4D3600C18 Bios set at 3600 Mhz. in mine without any issues. inner runs at about 48c outer ones at average 42c
Sorry, there was a problem. Please try again later.G.SKILL TridentZ RGB Series 32GB (2 x 16GB) 288-Pin DDR4 SDRAM DDR4 3600 (PC4 28800) Desktop Memory CL16 Is what I replaced mine with.
Sorry, there was a problem. Please try again later.Mine came with an Asus Prime Pro X570 motherboard. That board supports DDR4 RAM up to 4400 MHz.
Sorry, there was a problem. Please try again later.Mine came with 3200mhz ram so you should have no issue adding that
Sorry, there was a problem. Please try again later.Thank you for reaching out to us. The best way to purchase more RAM for the PC would be to look up the serial number on the side of the RAM and purchase the exact same stick. It is always recommended that you have matching sticks of RAM inside your PC to avoid incompatibility issues. If you have any further questions or concerns then please do not hesitate to give our tech support agents a call for any assistance; we're always happy to help. Tech Support: (855) 888-2039 [email protected] Hours of Operation: Monday - Friday: 8:30AM - 6:00PM PST Saturday: 9:30AM - 3:00PM PST -CyberPowerPC Support
Sorry, there was a problem. Please try again later.
