1-3 of 3 Answers
No need. Just plug it in and set the thermostat halfway and check with a thermometer. Just to 0 degrees.
Sorry, there was a problem. Please try again later.No install needed
Sorry, there was a problem. Please try again later.Good Morning Peg, Thank you for your inquiry. Please see the installation instructions: Two people should be used when moving the appliance. • Remove interior and exterior packaging prior to installation. Wipe the outside of the appliance with a soft, dry cloth and the inside with a lukewarm wet cloth. • Place the appliance on a fl oor that is strong enough to support it when it is fully loaded. • Do not place the appliance in direct sunlight or near sources of heat, such as a stove or heater, as this can increase electrical consumption. Extreme cold ambient temperatures may also cause the appliance to perform improperly. • Do not use the appliance near water, for example, in a wet basement or near a sink. • This appliance is intended for indoor household and garage use only. Freezers are tested to perform in temperatures ranging from 0°F to 110°F (-17°C to 43°C). It is not designed for outside installation, including anywhere that is not temperature controlled such as porches, vehicles, etc. • Before connecting the appliance to a power source, let it stand upright for approximately 6 hours. This will reduce the possibility of a malfunction in the cooling system from handling during transportation. • This appliance is 60.8 cm (23.9 inches) wide by 92.8 cm (36.5 inches) high by 63.2 cm (24.9 inches) deep. • Allow 12.7 cm (5 inches) of space between the back, sides and top of the appliance and all adjacent walls. • This appliance is intended for free-standing installation only and is not intended to be built into a cabinet or counter. Building in this appliance can cause it to malfunction. Thank you Anna
Sorry, there was a problem. Please try again later.