“Hi! Does this receiver work with 6ohm and 8ohm speakers? It's says on the specs 4ohm minimum but this is all new to me. Any help would be greatly appreciated. Thanks for your time!”
Answer This Question
1-5 of 5 Answers
The answer is yes, this AVR can support speakers from 4-8ohms. Just press and hold the main unit's STATUS and ZONE3 SOURCE at the same time for at least 3 seconds. Then select as below: 8 ohms: Select when the impedance for all of the connected speakers is 8 Ω/ohms or over. This is the default setting. 6 ohms: Select when the impedance for any of the connected speakers is 6 Ω/ohms. 4 ohms: Select when the impedance for any of the connected speakers is 4 Ω/ohms. Then press ENTER to complete the setting. Please refer to the owners manual, page 43.
Sorry, there was a problem. Please try again later.Yes, this reciever will work fine with 6 or 8ohm speakers
Sorry, there was a problem. Please try again later.Yes 4ohms are usually a speaker thats a lil harder to push but it will and it also will do 6 nd 8ohms. Most of my klipsch speakers are 8ohms and the 2 front are getting all the watts they need while all other speakers are getting about $75 to 80% of the remaining watts which is pretty standard. You would definitely want 6 or 8ohm speakers preferably for multi channel hook ups. If you have any 4ohm speakers i would suggest only 2 for the front R nd L speakers...And if you need more wattage(power) You can hook up a seperate amp to power them as well
Sorry, there was a problem. Please try again later.Yes, the receiver works with 6 and 8 ohms.
Sorry, there was a problem. Please try again later.Thanks for your quick reply Nicky!
Sorry, there was a problem. Please try again later.