“What wrong when I get a FO in my display widow an it shouts off if unplug it an plug it back in it well run again for about 30min”
Answer This Question
1-5 of 5 Answers
I had this same problem with the previous model. It gave an error code EC. On this model that error code is FO. My previous model lasted 14 mos. it ran fine for the first 12 months. I talked with Electrolux and they said it is a bad control board and since it was out of warranty, would not replace the unit. They also told me there are no replacement parts. They did not make any so when a part goes bad you have to replace the whole unit. I did purchase a new unit wit extended warranty. Hope this is not going to be a recurring problem.
Sorry, there was a problem. Please try again later.From product support page - If the display reads "F0" , check the following operating conditions. Outlet voltage should be 115V±10% and the surrounding temperature should be with in the range of 41 °F (5 °C) to 90 °F (32 °C). Unplug the unit and plug it in again under normal operating conditions. If the "F0" code persists, contact your Authorized Frigidaire Service Center.
Sorry, there was a problem. Please try again later.F0 means one of three conditions exist: 1 - the units is operating in an environment outside the 41F to 90F range; 2 - the supply voltage has dropped below about 105 volts or raised above about 126 volts; or it has a problem only a qualified service center can fix
Sorry, there was a problem. Please try again later.If the filter and intake fins are clean and you rest the filter change switch and it continues like mine, it needs to be serviced.
Sorry, there was a problem. Please try again later.Hello Frigidaire Shopper! The error code “FO” being displayed on the dehumidifier FFAD7033R1 is for an issue with the voltage. We would recommend using a different outlet to power the dehumidifier. We hope this information is helpful to you. Please, do not hesitate to contact us directly or via the Q&A forum on this website for any additional assistance. –Thanks!-
Sorry, there was a problem. Please try again later.