“How to install the filter properly? We were told that the leakage from the refrigerator to the crawling was due to the incorrect installment of the filter, the filter was removed and the leakage stopped. We have not put the filter back yet because we don't know how to properly place it. Is any one from the company willing to help us?”
Answer This Question
1-2 of 2 Answers
There are videos on YouTube showing how to remove and install the filter. On the FGHC2331PF you push the filter in until it clicks and then release it.
Sorry, there was a problem. Please try again later.Hello Frigidaire Friend! Please view the steps below for the replacement instructions for your water filter: 1 Turn Off the ice maker. 2 Remove the filter by pushing on the end/ face of the filter. 3 Slide the old water filter cartridge straight out of the housing and discard it. 4 Unpackage the new filter cartridge. Using the alignment guide, slide it gently into the filter housing until it stops against the snap-in connector at the back of the housing. 5 Push firmly until the cartridge snaps into place (you should hear a click as the cartridge engages the snap-in connector). 6 Press a drinking glass against the water dispenser while checking for any leaks at the filter housing. Any spurts and sputters that occur as the system purges air out of the dispenser system are normal. 7 After filling one glass of water, continue flushing the system for about four minutes. 8 Turn On the ice maker. 9 Press and hold the Water Filter button on the Ice & Water Dispenser control panel for three seconds. When the display changes from “Red” to “Green,” the status has been reset. We do welcome you to view this information in your use and care guide. If you have any additional questions or concerns, do not hesitate to contact us directly or by resubmitting a question on this Q&A website. -Kind Regards-
Sorry, there was a problem. Please try again later.