“Just got an Insignia washer, can I leave the plastic inlet filters that came already mounted in the washer for the hot and cold lines”

1-2 of 2 Answers

• Thank you for your inquiry! Yes, you can leave the plastic inlet filters that came pre-installed in your Insignia™ 4.1 Cu. Ft. Top Load Washer for the hot and cold water lines. These filters are designed to catch debris or sediment from your water supply, helping to protect the washer’s internal components from potential damage. They are located at the tip of the inlet hose, just before the rubber washer. Unless they become clogged or damaged, there’s no need to remove them. However, it’s a good idea to check and clean them periodically if you notice reduced water flow. Keith | Insignia Support

  Answered by InsigniaCustomerSupport 9 months ago

  Helpful (1)Unhelpful (0)

  Report

  Sorry, there was a problem. Please try again later.

• Yes you can I used my last plastic inlet filter for this washer.

  Answered by KeKe 8 months ago

  • Verified Purchase
  • 

  Helpful (0)Unhelpful (0)

  Report

  Sorry, there was a problem. Please try again later.